Hệ thống wifi
Power over Ethernet Surge Protector
Power over Ethernet Surge Protector
PoE SPD – DT-CAT 6A/EA
The DT-CAT 6A/EA is designed to protect sensitive data-processing equipment connected to a POE++ (Power over Ethernet) network from transient overvoltages.
This SPD is qualified with the maximum transmission speed and cabling category used for these Ethernet networks: 10 Gigabit Ethernet and Category 6A.
Obviously, it is applicable for Ethernet networks with lower categories. The DT-CAT 6A/EA surge protector is deployed in signal network applications with data transmission speeds up to 10 Gbps.
The transient protection circuit is based on high-energy gas discharge tubes (GDT) and a network of fast response silicon avalanche diodes (SAD) to achieve sharp clamping of very large surge events.
Power over Ethernet Surge Protector
PoE SPD – DT-CAT 6A/EA
Data cable protection device for high-speed networks
Protection class: Fine protection
High-quality RJ45 sockets
Low protection level at high current load
Earthing via DIN rail or connection cable
Support of Power over Ethernet ++ (PoE++/4PPoE) to 1 A in accordance with IEEE 802.3
Tested transmission quality in networks up to 10 GBit/s (Class EA) or CAT6
Rapid installation through plug-in version
lncl. DIN rail fastening set and earthing cable
Application example: 10 GBit Ethernet, 10/100 MBit Ethernet, PoE applications, IP camera systems, ISDN S0 interfaces
Including fastening set for mounting on the hat rail
Support for Power over Ethernet + to 1 A
High-quality RJ45 sockets
Rapid installation through connectable design
Tested transmission quality in networks up to 10 GBit (Class EA) or CAT6A
Wiring Diagram & Installation
PoE SPD – DT-CAT 6A/EA
The surge protector is housed in a shielded enclosure with high-quality RJ45 shielded jacks.
Wiring Diagram:
CE Certificate
Certified by TUV-Rheinland
TUV and CB certification. PoE Surge Protective Devices (SPD) tested accroding to IEC/EN 61643-21
